CHASSIS 8-3
EXTERIOR PARTS
FASTENER REMOVAL AND INSTALLATION
FASTENER (Type A)
Removal
• Depress the head of fastener center piece 1.
• Pull out the fastener a.
Installation
• Let the center piece stick out toward the head so that the
pawls 2 close.
• Insert the fastener into the installation hole.
NOTE:
To prevent the pawl 2 from damage, insert the fastener all the
way into the installation hole.
• Push in the head of center piece until it becomes flush with
the fastener outside face.
FASTENER (Type B)
Removal
• Pry up the head of fastener center piece 1 with a screw
driver.
• Pull out the fastener a.
SAMPLE
To Next Page
Loading...
