FI SYSTEM DIAGNOSIS 4-95
SENSORS
CMP SENSOR INSPECTION
The camshaft position sensor is installed on the cylinder head
cover. (4-33)
CMP SENSOR REMOVAL AND INSTALLATION
• Remove the CMP sensor. (3-27)
• Install the CMP sensor in the reverse order of removal.
CKP SENSOR INSPECTION
The crankshaft position sensor is installed on the right side of
middle crankcase cover. (4-35)
CKP SENSOR REMOVAL AND INSTALLATION
• Remove the starter clutch cover. (3-21)
• Install the starter clutch cover in the reverse order of removal.
IAP SENSOR INSPECTION
The intake air pressure sensor is installed at the rear side of the
air cleaner box. (4-37)
IAP SENSOR REMOVAL AND INSTALLATION
• Lift and support the fuel tank. (5-3)
• Remove the IAP sensor from the air cleaner box.
• Install the IAP sensor in the reverse order of removal.
TP SENSOR INSPECTION
The throttle position sensor is installed at the right side of the
No. 4 throttle body. (4-43)
TP SENSOR REMOVAL AND INSTALLATION
• Remove the TP sensor. (5-16)
• Install the TP sensor in the reverse order of removal.
TPS ADJUSTMENT
• Adjust the TP sensor. (4-20)
SAMPLE
To Next Page
Loading...
