6-6 EXHAUST SYSTEM
EXCVA INSTALLATION
• Make the No. 1 cable straight and turn the No. 1 cable
adjuster 1 in or out until the inner cable length A becomes
40 – 41 mm (1.57 – 1.61 in).
• After adjusting the inner cable length A, tighten the lock-nut
2.
No. 1 cable: 41G0CL
• Make the No.2 cable straight and turn in the cable adjuster 3
fully.
No. 2 cable: 41G0OL
• Connect the No. 1 cable 4 (41G0CL) and No. 2 cable 5
(41G0OP) to the EXCVA pulley.
• Check the EXCVA to adjustment position. (6-4)
• Install the pulley 6 to the shaft 7.
NOTE:
Make sure that the shaft’s line B and cable slots C facing
upward as shown.
Do not use the adjustable wrench to turn EXCVA pul-
ley so as not to cause damage to the internal gear of
EXCVA.
SAMPLE
To Next Page
Loading...
