6-10 EXHAUST SYSTEM
• After connecting the No. 2 cable 0, loosen the lock-nut A
and turn the adjuster B in or out until 16 – 17 mm (0.63 – 0.67
in) of the thread length F on the cable adjuster cam be pro-
vided and tighten the lock-nut A.
• Install the EXCVA. (6-6 to -7)
EXCVA ADJUSTMENT
1st step:
• Set the EXCVA to adjustment position. (6-4)
• Make sure that the No. 2 cable and No. 1 cable are fixed into
the clamp.
The cable slots of the EXCVA pulley must be located
upward (adjustment position). (6-4)
SAMPLE
To Next Page
Loading...
