EXHAUST SYSTEM 6-11
2nd step:
• Turn the mode select switch OFF.
• Turn the ignition switch ON to check the EXCVA operation.
• Turn the mode select switch ON.
• If C46 is not indicated on the LCD (DISPLAY), the adjustment
is correctly completed. In this case, it is unnecessary to pro-
ceed to 3rd step.
• If C46 is indicated, repeat the adjustment procedure from 3rd
and 4th step.
3rd step:
• This procedure is only required when C46 is indicated.
• Turn the ignition switch OFF.
• Insert the two copper wires into the back side of the position
sensor lead wire coupler 1.
• Disconnect the EXCVA motor lead wire coupler 2.
• To set the EXCV to fully close position, apply 12 volts to A
and B terminals.
Positive wire –– A (Pink wire) terminal
Negative wire –– B (Gray wire) terminal
ON
OFF
To prevent the motor damage, stop applying 12 V as
soon as the EXCV reaches fully close position.
12 V
SAMPLE
To Next Page
Loading...
