CHASSIS 8-55
• Set the swingarm pivot boss by its set screws.
• Tighten the swingarm boss nut to the specified torque.
Swingarm pivot boss nut: 65 N·m (6.5 kgf-m, 47.0 lb-ft)
INSPECTION AND DISASSEMBLY
SPACER
• Remove the spacers from swingarm.
• Remove the spacers from the cushion lever.
• Inspect the spacers for any flaws or other damage. If any
defects are found, replace the spacers with new ones.
SWINGARM BEARING
• Insert the spacer into bearing and check the play when mov-
ing the spacer up and down.
• If excessive play is noted, replace the bearing with a new one.
SAMPLE
To Next Page
Loading...
