Suzuki GSX-R1000K5 - Page 377

8-54 CHASSIS
• Hold the swingarm pivot shaft 5 and remove the swingarm
pivot nut 6.
 09944-28320: Hexagon socket (19 mm)
• Draw out the swingarm pivot shaft.
• Remove the rear suspension assembly.
• Remove the cushion rods 7.
• Remove the rear fender (lower) 8.
• Remove the chain cases 9 and chain buffer 0.
SWINGARM PIVOT BOSS REMOVAL AND INSTALLATION
• Remove the swingarm. (8-53 to -54)
• Remove the swingarm pivot boss nut.
NOTE:
Remove the swingarm pivot boss when only replacing it.
• Remove the swingarm pivot boss by removing its set screws.
SAMPLE