CHASSIS 8-81
• Apply SUZUKI SILICONE GREASE to the push rod end.
99000-25100: SUZUKI SILICONE GREASE
MASTER CYLINDER INSTALLATION
Install the master cylinder in the reverse order of removal. Pay
attention to the following points:
• Apply THREAD LOCK to the master cylinder mounting bolts.
99000-32050: THREAD LOCK “1342” (USA)
99000-32110: THREAD LOCK SUPER “1322” (Others)
• Tighten each bolt to the specified torque.
(Brake hose routing: 10-26)
Brake hose union bolt 1: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
Master cylinder mounting bolt 2:
10 N·m (1.0 kgf-m, 7.0 lb-ft)
Master cylinder rod lock-nut 3:
18 N·m (1.8 kgf-m, 13.0 lb-ft)
• Adjust the brake pedal height. (2-25)
* The seal washers should be replaced with the new
ones to prevent fluid leakage.
* Bleed air from the system after reassembling the
master cylinder. (2-26)
SAMPLE
To Next Page
Loading...
