6-8 EXHAUST SYSTEM
EXCVA INSPECTION
4-82
EXCV CABLE REPLACEMENT
• Disconnect the EXCV cables from the EXCVA pulley.
(6-4 to -5)
• Remove the cable guide.
• Disconnect the EXCV cables from the EXCV pulley.
(6-14)
NOTE:
The EXCV cables are identified by the plated chrome color and
shape.
No. 1 cable 1: 41G0CL
No. 2 cable 2: 41G0OP
• Connect the EXCV cables (No. 1 and No. 2) temporarily to the
EXCVA pulley.
• Check or adjust the clearance A becomes the adjuster end
and EXCVA pulley to provide 3.0 mm (0.12 in) and more.
• Install the muffler body. (6-14)
• Make the No. 1 cable straight and turn the No. 1 cable
adjuster 3 in or out until the inner cable length B becomes
40 – 41 mm (1.57 – 1.61 in).
• After adjusting the inner cable length B, tighten the lock-nut
4.
No. 1 cable: 41G0CL
41G0OP
41G0CL
SAMPLE
To Next Page
Loading...
