8-72 CHASSIS
• Apply SUZUKI SILICONE GREASE to the brake lever mount-
ing bolt.
99000-25100: SUZUKI SILICONE GREASE
• Align the convex part A of brake light switch with the hole B
of master cylinder when installing the brake light switch.
MASTER CYLINDER INSTALLATION
Install the master cylinder in the reverse order of removal. Pay
attention to the following points:
• When installing the brake master cylinder 1 onto the handle-
bars 2, align the master cylinder holder’s mating surface with
punched mark A on the handlebars and tighten the upper
clamp bolt 3 first as shown.
Front brake master cylinder mounting bolt:
10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Tighten the union bolt. (Brake hose routing: 10-25)
Brake hose union bolt: 23 N·m (2.3 kgf.m, 16.5 lb-ft)
“UP” mark
Clearance
* The seal washers should be replaced with the new
ones to prevent fluid leakage.
* Bleed air from the system after reassembling the
master cylinder. (2-26)
SAMPLE
To Next Page
Loading...
