EXHAUST SYSTEM 6-13
If the measured voltage is more than specification, adjust the
No.2 cable adjuster as follows:
• Set the EXCVA to adjustment position. (6-4)
• Turn out the No. 2 cable adjuster 1.
• Repeat the above procedure until the output voltage comes
within the specified value.
Position sensor output voltage
EXCV is fully open: 3.7 output voltage 4.5 V
• After adjusting the EXCV cables, perform 2nd step to confirm
C46 is not indicated.
EXCV/MUFFLER REMOVAL
• Disconnect the two cables from the EXCVA pulley. (Refer to
the EXCVA REMOVAL procedures.) (6-4 to -5)
• Remove the right under cowling. (8-5)
• Move the front footrest assembly. (8-5)
• Remove the cable guide.
• Loosen the connector bolt 1.
• Remove the muffler mounting bolts 2.
• Remove the muffler body 3.
Adjusting the No. 2 cable with the EXCV fully opened
can damage the EXCVA. Be sure to adjust the No. 2
cable with the EXCV set in adjustment position.
SAMPLE
To Next Page
Loading...
