9-38 ELECTRICAL SYSTEM
IGNITION SWITCH REMOVAL
• Remove the air cleaner box. (5-13)
• Disconnect the ignition switch lead wire coupler (Green) 1.
• Disconnect the immobilizer lead wire coupler (Black) 2.
(For E-02, 19, 24)
• Remove the cable guide 3.
• Remove the ignition switch mounting bolts with the special
tools.
09930-11920: Torx bit JT40H
09930-11940: Bit holder
IGNITION SWITCH INSTALLATION
Install the ignition switch in the reverse order of removal.
Pay attention to the following points:
• Apply thread lock to the ignition switch bolts.
99000-32050: THREAD LOCK “1342” (USA)
99000-32110: THREAD LOCK SUPER “1322” (Others)
When reusing the ignition switch bolt, clean thread
and apply the THREAD LOCK.
SAMPLE
To Next Page
Loading...
