CHASSIS 8-71
• Inspect the piston surface for any scratches or other damage.
• Inspect the primary cup, secondary cup and dust seal for
wear or damage.
MASTER CYLINDER REASSEMBLY
Reassemble the master cylinder in the reverse order of disas-
sembly. Pay attention to the following points:
Specification and classification: DOT 4
• Install the O-ring to the brake hose connector.
• Apply SUZUKI SUPER GREASE “A” to the push rod.
99000-25030: SUZUKI SUPER GREASE “A” (USA)
99500-25010: SUZUKI SUPER GREASE “A” (others)
* Clean the master cylinder components with fresh
brake fluid before reassembly. Never use cleaning
solvent or gasoline to clean them.
* Do not wipe the components with a rag.
* Apply brake fluid to the cylinder bore and all the
component to be inserted into the bore.
Use a new O-ring to prevent the fluid leakage.
SAMPLE
To Next Page
Loading...
