3-86 ENGINE
WATER PUMP
• Apply SUZUKI SUPER GREASE “A” to the O-ring.
99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Tighten the water pump mounting bolts 1 to the specified
torque.
Water pump mounting bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
NOTE:
Pass the gear position switch lead wire 2 under the water pump
rib and clamp the gear position switch lead wire.
• Apply engine coolant to the O-ring.
• Install the water inlet cover 3.
Water inlet cover bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
GENERATOR ROTOR
• Degrease the tapered portion A of generator rotor and also
the crankshaft B. Use nonflammable cleaning solvent to wipe
off oily or greasy matter and make these surfaces completely
dry.
Use a new O-ring to prevent oil leakage.
Use a new O-ring to prevent engine coolant leakage.
SAMPLE
To Next Page
Loading...
