ENGINE 3-103
CAM CHAIN TENSION ADJUSTER
• Retract the push rod by pushing the stopper 1.
• Install a new gasket 2.
• Install the cam chain tension adjuster 3 and tighten its
mounting bolts.
Cam chain tension adjuster mounting bolt:
10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Install the spring 4.
• Install the gasket 5 and cam chain tension adjuster cap bolt
6.
NOTE:
Click sound is heard when the cam chain tension adjuster cap
bolt is installed.
• Tighten the cam chain tension adjuster cap bolt to the speci-
fied torque.
Cam chain tension adjuster cap bolt:
23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Cut the wire clamps 7.
• After installing the cam chain tension adjuster, rotate the
crankshaft (some turns), and recheck the positions of the
camshafts. (3-104)
Use a new gasket to prevent oil leakage.
After installing the cam chain tension adjuster, check
to be sure that the adjuster works properly by check-
ing the slack of cam chain.
SAMPLE
To Next Page
Loading...
