FI SYSTEM DIAGNOSIS 4-47
Step 3
1) Connect the TP sensor coupler 1 to the test harness.
2) Turn the ignition switch ON.
3) Measure the TP sensor output voltage at the coupler
(between + P/B and - B/Br) by turning the throttle grip.
TP sensor output voltage
Throttle valve is closed: Approx. 1.1 V
Throttle valve is opened: Approx. 4.3 V
09900-25008: Multi-circuit tester set
Tester knob indication: Voltage ()
Is the voltage OK?
4) After repairing the trouble, clear the DTC using SDS tool.
(4-27)
V
ECM
TPS
P/B
R
B/Br
3
YES
• P/B, Red or B/Br wire open or shorted to
ground, or poor 8, A or S connection
• If wire and connection are OK, intermittent trou-
ble or faulty ECM.
• Recheck each terminal and wire harness for
open circuit and poor connection.
• Replace the ECM with a known good one, and
inspect it again.
NO
If check result is not satisfactory, replace TP sen-
sor with a new one.
ECM coupler (Harness side)
3
(Black) (Gray)
SAMPLE
To Next Page
Loading...
