FI SYSTEM DIAGNOSIS 4-49
Step 1 (When indicating P0115-H:)
1) Turn the ignition switch OFF.
2) Lift and support the fuel tank. (5-3)
3) Check the ECT sensor coupler for loose or poor contacts.
If OK, then check the ECT sensor lead wire continuity.
4) Disconnect the ECT sensor coupler and ECM coupler.
5) Check the continuity between B/Bl wire A and terminal 0.
6) Also, check the continuity between B/Br wire B and terminal
S.
ECTS lead wire continuity:
Continuity ()
09900-25008: Multi-circuit tester set
09900-25009: Needle pointed probe set
Tester knob indication: Continuity test ()
Is the continuity OK?
7) After repairing the trouble, clear the DTC using SDS tool.
(4-27)
1
YES Go to Step 2.
NO B/Bl or B/Br wire open
1
ECM coupler (Harness side)
(Black)
(Gray)
!
SAMPLE
To Next Page
Loading...
