CHASSIS 8-47
• Tighten the sprocket mounting nuts to the specified torque.
Rear sprocket nut: 93 N·m (9.3 kgf-m, 67.5 lb-ft)
NOTE:
Stamped mark A on the sprocket should face outside.
• Install the collar 2.
BRAKE DISC
• Apply THREAD LOCK to the disc bolts and tighten them to
the specified torque.
NOTE:
Make sure that the brake disc is clean and free of any greasy
matter.
99000-32130: THREAD LOCK SUPER “1360”
Brake disc bolt: 35 N·m (3.5 kgf-m, 25.5 lb-ft)
• Install the collar 1.
REAR AXLE
• Remount the rear wheel and rear axle shaft, and install the
washer 1 (Except for E-03, 28, 33) and rear axle nut 2.
• Adjust the chain slack after rear wheel installation. (2-21)
SAMPLE
To Next Page
Loading...
