CHASSIS 8-89
• Stake the joint pin by turning (approximately 7/8 turn) the
pressure bolt “A” 3 with the bar until the pin end diameter
becomes the specified dimension.
Pin end diameter specification D
• Adjust the drive chain, after connecting it. (2-21)
DID 5.50 – 5.80 mm (0.217 – 0.228 in)
* After joining of the chain has been completed, check
to make sure that the link is smooth and no abnormal
condition is found.
* Should any abnormal condition be found, reassem-
ble the chain link using the new joint parts.
SAMPLE
To Next Page
Loading...
