9-18 ELECTRICAL SYSTEM
GEAR POSITION SWITCH
• Lift and support the fuel tank. (5-3)
• Disconnect the gear position switch coupler and check the
continuity between Blue and Black/White with the transmis-
sion in “NEUTRAL”.
09900-25008: Multi-circuit tester set
Tester knob indication: Continuity test ()
• Connect the gear position switch coupler to the wiring har-
ness.
• Turn the ignition switch to “ON” position and side-stand to
upright position.
• Measure the voltage between Pink and Black/White lead
wires using the multi-circuit tester when shifting the gearshift
lever from low to top.
09900-25008: Multi-circuit tester set
09900-25009: Needle pointed probe set
Tester knob indication: Voltage ()
Gear position switch voltage: 0.6 V and more
* Low to top gear position (Pink + – B/W -)
* Except neutral position (Pink + – B/W -)
When disconnecting and connecting the gear position
switch coupler, make sure to turn OFF the ignition
switch, or electronic parts may get damaged.
Use the special tool, to prevent the rubber of the water
proof coupler from damage.
ON (Neutral)
Blue Black/White
OFF (Except neutral)
V
SAMPLE
To Next Page
Loading...
