9-24 ELECTRICAL SYSTEM
Step 5
1) Inspect the ignition coil/plug caps. (9-26)
Is the ignition coil/plug cap OK?
Step 6
1) Measure the crankshaft position sensor peak voltage and its resistance. (9-27 to -28)
NOTE:
The crankshaft position sensor peak voltage inspection is applicable only with the multi circuit tester and
peak volt adaptor.
Is the peak voltage and resistance OK?
YES Go to Step 6.
NO
• Poor connection of the ignition coil/plug cap(-s).
• Faulty ignition coil/plug cap(-s).
YES
• Faulty ECM
• Open or short circuit in wire harness
• Poor connection of ignition couplers
NO
• Faulty CKP sensor
• Metal particles or foreign material being stuck on the CKP sensor and rotor tip
SAMPLE
To Next Page
Loading...
