ENGINE 3-11
• Gradually raise the rear side of the engine assembly, and
then put the drive chain on the driveshaft.
• Install all engine mounting bolts, spacers and tighten them
temporarily. (3-12)
• Tighten the engine mounting thrust adjusters to the specified
torque.
Engine mounting thrust adjuster:
23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Tighten the engine mounting thrust adjuster lock-nuts to the
specified torque with the special tool.
Engine mounting thrust adjuster lock-nut:
45 N·m (4.5 kgf-m, 32.5 lb-ft)
• Tighten all engine mounting bolts and nuts to the specified
torque. (3-12)
NOTE:
The engine mounting nuts are self-locking. Once the nuts have
been removed, they are no longer of any use.
• Tighten the engine mounting pinch bolts to the specified
torque. (3-12)
Be careful not to catch the wiring harness between the
frame and the engine.
SAMPLE
To Next Page
Loading...
