Suzuki GSX-R1000K5 - Page 71

ENGINE 3-17
CYLINDER HEAD
• Remove the water hose 1.
• Remove the thermostat cover 2 and thermostat.
THERMOSTAT INSPECTION (7-9)
• Remove the ECT sensor 3.
ECT SENSOR INSPECTION (7-7)
• Remove the cylinder head bolts (M6) 4.
• Remove the cylinder head bolts and washers.
NOTE:
When loosening the cylinder head bolts, loosen each bolt little
by little diagonally.
• Remove the cylinder head 5.
• Remove the cylinder head gasket and dowel pins.
CLUTCH
• Remove the clutch cover.
• Hold the clutch housing with the special tool.

 09920-53740: Clutch sleeve hub holder
• Remove the clutch springs.
NOTE:
Loosen the clutch spring set bolts little by little and diagonally.
Do not damage the clutch plates by the special tool.
SAMPLE