Suzuki GSX-R1000K5 - Page 79

ENGINE 3-25
TRANSMISSION
• Remove the transmission 1 and O-rings.
• Remove the dowel pins 2.
MIDDLE CRANKCASE
• Remove the crankcase bolts.
• Remove the crankcase bolts (M6).
• Remove the crankcase bolts (M8).
• Remove the crankshaft journal bolts (M9).
NOTE:
Loosen the crankcase bolts diagonally with the smaller sizes
first.
• Remove the middle crankcase and dowel pins.
BALANCER SHAFT
• Remove the balancer shaft 1.
CRANKSHAFT
• Loosen the bearing cap bolts by using 12 mm, 12 point socket
wrench, and tap the bearing cap bolt lightly with plastic ham-
mer to remove the bearing cap.
• Remove the O-ring 1.
• Remove the crankshaft and thrust washers 2.
SAMPLE