Suzuki LS650 Savage - Page 108

ENGINE 97
2. Install the exhaust rocker arm shaft pan way
into the cylinder head cover.
3. InS lalllh e exhaust rocker arm ( Figure 111 ) and
push the rocker arm through it. Make
SU f e the
exhaust ro
cke r arm tab is l ocated on the
decompre ss ion actuator shaft as shown in Figure
112 .
4. In sta ll the wave washer ( Figure 113 ) and push
the rocker arm
shaft in umil it aligns with the bolt
hole
in the cylinder head cover ( Figure 114 ), Don't
push the shaft in too far as the hole alignment will
be off and you will be unable to install the bolt.
5. Insla ll the boll and new sealing washer (I-ig-
ure 115 ) and tighten securely.
6. Install the intake rocker arm shaft part way inlo
the cylinder head cover.
7. Install the intake rocker arm ( Figure 116 ) and
push the rocker arm through
it.
8. in sla llthc wave washer ( Figure 117 ) and push
the rocker arm
shaf t in . Don't push the shaft in too
far as the bolt hole in
the cylinder head cover will
be blocked (
Figure U8) and you will be unable to
in sta ll the bolt during cylinder head cover
in stallntion.