324
NOTE
Figure 86 is shown with the exhau
st
syst
em
removed for clarity.
II
is not
IItCessOl)'
10
remove
the syst
em
for
Ihis
procedllre.
5.
Pull the front
ri
ght-hand footpcg and front brake
pedal assembly (Figure 86)
off
the through-bolts.
NOTE
If
the foo/peg
and
brake pedal
assembly is going to be left
off/or
some
lillie. reinslaf/ the
'washers
allli
cap nllts
ontO
the ,"rough-bolls.
6.
Remove the coller pin
(A
. • 'ig
ur
e 87) and
withdraw
th
e pivot pin securing the brake cable and
rcar brake light switch cable to the brake pedal.
7.
Remove the cotter pin and washer (B.
Figure
87) and slide the brake pedal (C. Figure 87) and
return spring
off
the pivot post
on
the backside
of
the
ri
ght-hand footpcg brackc!.
8.
Loose
n the locknuts (D, Figure
87
) on
th
e brake
cable on the footpeg assembly and remove the
brake cable from the receptacle on the footpeg
assembl
y.
9.
Remove the screws and nuts (
Figure
88)
securing the brake cable and bracket to the frame.
10.
Loosen the locknuts (A. Figure
89
) on the
brake cable on the swing arm.
11
. Remove the brake cable from the receptacle (8.
Figur
e
89
) on the swing arm and remove the brake
cable.
CHAPTER
ELEVEN
®
To Next Page
Loading...
