56
(Honda part
No.
07700-00/0001) is
made specific
all
y fOT rhis purpose
and
if
carefully u
sed
, will nOl m
ar
or dam-
age the
SIlrface
on
th
e inspection cover.
7.
Remove the
va
l
ve
timing inspection
cover
(Fig-
ur
e 94) on the left-hand crankcase cover.
8.
Remove the bolts (
Figure
95) securing bo
th
valve adjuster cove rs on cylinder head. Remove
bo
th
covers.
NO
TE
A cylinder at TDC will have free play
in
bOlh
the intake ami exhaust \'a/VI'
rocker arms indicating thaI both rhe
intake and exhaust
m/l't'S
are closed.
9.
U
se
a )7
mm
wr
ench (Figure 96)
on
the
altern
ator
rotor bolt . Rot
ate
the
engine
clockwise.
as viewed from the le
ft
-ha
nd
side. unlillhe engine
is
al
lOp
dead center
(TOe)
on the compression
stroke. Align
th
e groove
on
th
e end
of
th
e alternator
r
otor
with the notch in the al
ternator
cover (
Fig-
ur
e 97).
10
. With the groove aligned with the notch.
jiggle
both rocker
arms
and
make sure b
Olh
have free
pla
y.
If one rocker
arm
is sti
ll
under tcnsion, rotate
the engine an additional
180
degrees
until
bo
th
r
oc
ker
arms
have free pl
ay.
II. Again
check
that the groove
on
the
end
of
the
alt
ernator
rotor
is aligned with the notch in the
alternat
or
cover.
NOTE
Th
e fo/lowing steps
ar
e shown with
Ihe
engine removed
fr
om the frame and
CHAPTER THREE
To Next Page
Loading...
