3-68 ENGINE
• Install the washer and clutch sleeve hub nut.
NOTE:
The convex side of the washer faces outside.
• Tighten the clutch sleeve hub nut to the specified torque with
the special tool.
Clutch sleeve hub nut: 70 N·m (7.0 kgf-m, 50.5 lb-ft)
09920-53730: Clutch sleeve hub holder
• Stake the clutch sleeve hub nut with a center punch.
• Install the clutch springs and clutch release plate.
• Tighten the clutch spring bolts diagonally.
• Install the clutch release arm by aligning the arm with the cen-
ter of the clutch.
INSIDE
Washer
OUTSIDE
To Next Page
Loading...
