ENGINE 3-69
CAM CHAIN
• Install the cam chain.
GENERATOR
• Install the starter driven gear 1.
• Install the key 2.
NOTE:
Degrease the tapered portion of the generator rotor assembly
and also the crankshaft. Use nonflammable cleaning solvent to
wipe off the oily or greasy matter to make these surfaces com-
pletely dry.
• Install the generator rotor and tighten the generator rotor nut
to the specified torque with the special tool.
Generator rotor nut: 160 N·m (16.0 kgf-m, 115.5 lb-ft)
09930-44520: Rotor holder
• Install the one-way clutch onto the clutch wheel with facing
the “
➞
” mark inside.
• Install the one-way clutch inner race 3 with facing the
grooved side inside.
• Install the clutch wheel.
To Next Page
Loading...
