Suzuki Ozark - Page 126

4-6 DRIVE TRAIN
• Remove the bearing and oil seal out of the cover with a suit-
able tool.
NOTE:
If there is no abnormal condition, the bearing/oil seal removal is
not necessary.

• Remove the oil seal out of the case with a suitable tool.
NOTE:
If there is no abnormal condition, the oil seal removal is not nec-
essary.

• Remove the bearing out of the case with the special tool.
 09913-70210: Bearing installer set
NOTE:
If there is no abnormal condition, the bearing removal is not nec-
essary.

• Remove the pinion gear shaft coupling joint with the special
tools.
 09923-74510: Bearing puller
09930-30104: Sliding shaft
• Remove the oil seal out of the case with a suitable tool.
NOTE:
If there is no abnormal condition, the oil seal removal is not nec-
essary.

The removed bearing and oil seal must be replaced
with the new ones.
The removed oil seal must be replaced with a new one.
The removed bearing must be replaced with a new
one.
The removed oil seal must be replaced with a new one.