4-8 DRIVE TRAIN
• Remove the pinion gear pilot bearing with the special tools.
09921-20210: Bearing puller
09930-30104: Sliding shaft
NOTE:
If there is no abnormal condition, the bearing removal is not nec-
essary.
UNIVERSAL JOINT
• Remove the C-rings from the universal joint.
• Remove the bearings by tapping with the special tool and
hammer.
09913-70210: Bearing installer set
• Remove the universal joint.
The removed bearing must be replaced with a new
one.
Replace the removed C-ring with a new one.
To Next Page
Loading...
