Suzuki Ozark - Page 133

DRIVE TRAIN 4-13
BEVEL PINION GEAR SHAFT BEARING
• Drive the bearing onto the shaft with the special tool.
 09913-70210: Bearing installer set
BEVEL PINION GEAR/SHIM/LOCKNUT
[FINAL ASSEMBLY]
• Install the new O-ring 1 onto the pinion gear shaft.
• Install the shim, pinion gear assembly and new bearing
locknut.
• Tighten the new locknut to the specified torque.
 09921-21820: Bearing locknut wrench
 Bearing locknut: 100 N·m (10.0 kgf-m, 72.5 lb-ft)
NOTE:
After the backlash and tooth contact have been checked or
adjusted, stake the nut with a center punch.
BEVEL PINION GEAR SHAFT OIL SEAL
• Install the new stopper ring to pinion gear shaft securely.
• Install the new oil seal to the gear case with the special tool.
• Apply grease to the new oil seal lip groove.
 09913-85210: Bearing/oil seal installer
 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
NOTE:
After the backlash and tooth contact have been checked or
adjusted, install the oil seal.