Suzuki Ozark - Page 177

CHASSIS 7-13
• Install the dust seals 1 into the front wheel hub with stamped
mark facing to outside by using the special tool.
 09913-70210: Bearing installer set
• Apply SUZUKI SUPER GREASE “A” to the dust seal’s lip.
 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Install the spacer 2 to the wheel hub.
• Install the front disc to the front wheel hub. (7-24)
• Install the wheel hub to the front axle 3.
• Install the front brake caliper. (7-22)
• Tighten the front wheel hub nut to the specified torque.
 Front wheel hub nut: 75 N·m (7.5 kgf-m, 54.0 lb-ft)
• Install the cotter pin into the front axle as shown.
• Install the front wheel. (7-12)

NOTE:
Bend the cotter pin securely for fear that the cotter pin touches
the wheel center cap.
Replace the removed cotter pin with a new one.