5: Function Reference
The following table gives the command line equivalents for each of the preceding
parameters:
Description “F100” followed by: Comments
Ethernet address
(MAC address)
EA Displays information
IP Address IP Displays, configures and reboots
Subnet Mask SM Displays, configures and reboots
Default Gateway G Displays, configures and reboots
IP Address, Subnet Mask,
and Default Gateway
IC Displays several IP parameters
10 100 BASE-T BASET Displays network port setting
Remote Lockout L (for status), LOCK, UNLOCK Displays and configures
Flash CRC ST Displays information
RAM ST Displays information
Serial ST Displays information
Version Test
(NVRAM Ver)
ST Displays information
Group 2
The following expanded command set is available through the command line interface:
Description “F100” followed by: Comments
Burn Host BH Configure
Burn BU Commit action
Burn Bootloader BUB Commit action
Burn Filesystem BF Commit action
Configure NTP & SNMP Parameters CONFIG Move files
Factory Mode Jumper J Display only
Reboot K I L L
Commit action – reboot the XL-
GPS
Change User Password P Configure
Ping PI Commit action
Change User Name PN Commit action
Page 108 of 221 .................................098-00116-000 Rev. A
To Next Page
Loading...
Need help?
General
