Configuring and Testing SNMP
Follow the manual to load the snmp.conf configuration file into the XL-GPS. The IP address
of the HP OpenView PC must be in both the public and private communities.
Test Procedure
Testing “Get”
1. From the Network Node Manager root level double click the icon “Internet”. Select the
icon corresponding to your test subnet, e.g. “192.168.11”, and double click. Double
click the “Segment1” icon.
2. Select the icon labeled “NIC” by single clicking with the mouse.
3. Select the menu item “xlGps->Status”, “xlGps->Configuration”, then “xlGps->Faults”.
Verify the values by comparing with the output of the keypad display.
Testing “Set”
1. Follow “Get Testing” procedure steps 1-2.
2. Select the menu item “Tools->SNMP MIB Browser”. A popup titled “Browse MIB” will
appear.
3. In the “Browse MIB” popup descend the MIB tree to “iso -> org -> dod -> private ->
enterprises -> symmetricomTtm -> products -> xlGps -> xlGpsSystem -> systemFault
-> systemFaultConfig -> systemFaultConfigMasks” by clicking the “+” symbol next to
each entry.
4. In the “Browse MIB” popup select the “maskPllSynthesizer” entry. In the “MIB
Instance” field type 0. In the “SNMP set value” field type 1. Click the “Set” button.
5. Verify that a popup appears saying “Set has completed successfully”.
6. Select the menu item “xlGps->Configuration”. In the popup “xlGpsconfig” verify that
the “maskPllSynthesizer” entry is set to “disabled”.
7. In the “Browse MIB” popup select the “maskPllSynthesizer” entry. In the “MIB
Instance” field type 0. In the “SNMP set value” field type 2. Click the “Set” button.
8. Verify that a popup appears saying “Set has completed successfully”.
9. Select the menu item “xlGps->Configuration”. In the popup “xlGpsconfig” verify that
the “maskPllSynthesizer” entry is set to “enabled”.
10. Repeat steps 4-9 in turn for each additional entry under systemFaultConfigMasks.
Trap Testing
1. Perform an action to generate a trap.
098-00116-000 Rev. A............................... Page 193 of 221