F126 – Options Key Entry
F126 – Options Key Entry
Use function F126 to enter the Options Key, which enables certain functions (e.g., PPO,
TIET, NTP, FREQMEAS) if the correct key is entered. To check the status of these XL-GPS
options, see “F117 – Factory Configuration” on page142. After entering the key code using
F126, reboot the XL-GPS.
To set the Options Key code, enter the following:
F126<S><KC><CR><LF>
where:
F
= ASCII character F (f or F for input string).
126
= the function number
<S>
= ASCII space character one or more
<KC>
= Key Code, 0 to 999999999999999. A value of all nines will clear all Option enable flags.
<CR>
= carriage return character
<LF>
= line feed character
For example, enter:
F126<S>5674397586090<CR>
XL-GPS responds:
OK<CR><LF>
Reboot the instrument to activate the option, then use function F117 to verify that the correct
code was entered.
098-00116-000 Rev. A............................... Page 149 of 221