A: Using F100 Configuration
• Make note of the IP Address.
For other operating systems and configurations, consult the appropriate documentation for
obtaining the FTP server’s IP address.
Copy the Configuration Files to the FTP Server
Telnet to the XL-GPS or open a terminal session to it over the serial port.
Using the command line, enter the commands below. Replace <IP Address> with that of
the workstation/FTP Server. Leave <subdir> blank - the FTP server will save the files in
anonymous’s home directory.
Note: See “Using the Command Line Interface” on page31 if you need instructions for con-
necting to the command line interface
To get the NTP config files, type:
>f100 config ntp get host:<IP Address> dir:<subdir>
To get the SNMP config file, type:
>f100 config snmp get host:<IP Address> dir:<subdir>
To get the SNMP and NTP config files, type:
>f100 config ntp snmp get host:<IP Address> dir:<subdir>
Here’s an example of a successful SNMP and NTP config file transfer:
>f100 config ntp snmp get host:192.168.0.1 dir:
Host config ip 192.168.0.1 already configured
Source file /config/snmp.conf bytes read: 1275
Dest file snmp.conf bytes written: 1275
Source file /etc/ntp.conf bytes read: 1166
Dest file ntp.conf bytes written: 1166
Source file /etc/ntp.keys bytes read: 44
Dest file ntp.keys bytes written: 44
Configuration files transferred successfully!
If you get “Error: Can’t write file” when you enter the get command, verify the
following FTP server items:
• FTP server is running.
• Anonymous has a home directory.
• The home directory for Anonymous has read, write, and delete enabled (make sure to
apply changes).
Page 172 of 221 .................................098-00116-000 Rev. A