Multicode Output (87-6002-XL1)
Multicode Output (87-6002-XL1)
The Multicode Output option card generates four AM time code outputs. Each of the outputs
can be independently configured to generate a specified time code signal. All outputs
configured for IRIG-A will output the same type of IRIG-A (e.g., IRIG-A 130). Likewise, all
outputs configured for IRIG-G will output the same type of IRIG-G. All the other time code
types are completely independent from each other.
The Multicode Output card is configured from the front panel keypad and command line
interface using F42 - Multicode Output Configuration๎(page๎69)
Note1: This module is not RoHS.
Note2: There are 8 adjustments potentiometers on the PC๎board behind the 4 BNC
๎connectors. There are two potentiometers per BNC connector, an amplitude adjustment,
and a ratio adjustment. Each potentiometer is labeled as to its connector (1 - 4), and
adjustment, amplitude or ratio. See Adjusting Amplitude and Modulation Ratio.
Note3: Follow good ESD precautions when handling this board.
098-00116-000 Rev. A............................... Page 157 of 221