Symmetricom XL-GPS User Manual

5: Function Reference
F100 G – Gateway
Note: F100 G can be used concurrently with F100 IP and F100 SM. See the last example
provided in the F100 IP – IP Address section, which starts on page109.
Use function F100 G to display or configure the Default Gateway. To set the Default
Gateway and restart the unit, enter:
F100<S>G<S><nnn.nnn.nnn.nnn><CR>
where:
F
= ASCII character F
100
= unit function number
<S>
= space
IP
= specify IP command
<nnn.nnn.nnn.nnn>
= dotted decimal address (0 to 255)
<CR>
= input line terminator
For example, enter:
F100 G 206.54.0.17<CR>
XL-GPS responds:
OK<CR><LF>
RESETING THE UNIT<CR><LF>
PLEASE WAIT…<CR><LF>
To obtain the Default Gateway of the unit Standard network port, enter:
F100 G<CR>
XL-GPS responds:
F100 G <nnn.nnn.nnn.nnn><CR><LF>
where “<nnn.nnn.nnn.nnn>” is the dotted decimal address notation.
An example of the response is:
F100 G:206.54.0.1<CR><LF>
Page 112 of 221 .................................098-00116-000 Rev. A

Symmetricom XL-GPS Specifications

General

Brand	Symmetricom
Model	XL-GPS
Category	Receiver
Language	English