F100 – Network Port Configuration & XL-GPS Firmware
To test if the XL-GPS’s network port has a good connection, enter the following using in a
serial port session:
>f100 PI<CR>
XL-GPS responds:
PING : REMOTE HOST FOUND.<CR><LF>
or it responds:
PING : REMOTE HOST NOT FOUND.<CR><LF>
F100 PN – Change User Name
Use function F100 PN to change a user name. In a network port session, F100 PN changes
the name of the user you logged in as; operator or guest. In a serial port session, F100 PN
changes the name of the operator user. See “Command Line Interface” on page41.
To change the user name, enter:
F100<S>PN<CR>
where:
F
= ASCII character F
100
= unit function number
<S>
= space
PN
= specify User Name command
<CR>
= input line terminator
XL-GPS responds:
ENTER NEW USER NAME:
When you enter a new user name, XL-GPS responds:
CONFIRM NEW USER NAME:
Enter the same new user name again, to confirm the spelling. If the same new user name
has been entered twice, XL-GPS responds:
OK<CR><LF>
098-00116-000 Rev. A............................... Page 125 of 221