4: User Interfaces
Logging In
Two user names are available for logging in to the network port’s command line interface:
“operator” and “guest”. The serial port’s command line interface does not require the user to
log in.
Operator Login
The Operator has full privileges to change the settings in all the XL-GPS’s functions and to
perform firmware updates. As shipped, you can log in as Operator using:
User Name: operator
Password: janus
To maintain security, change the Operator password at installation.
If you are logged in as “operator”, the only command line interface function you cannot
perform is changing the Guest password.
Guest Login
Use the guest login to view function settings. As shipped, you can log in as guest using:
User Name: guest
Password: ttm
To maintain security, change the Guest password at installation.
If you try to use a function that is not accessible from the guest login, you will see a message
such as “Access denied” or “Command canceled”.
Logging Out
You can log out using the following commands:
logout
logoff
exit
quit
Changing Username and Password
To change the user name and password, use the following commands:
l
“F100 P – Change User Password” on page123
l
“F100 PN – Change User Name” on page125
Page 42 of 221 .................................098-00116-000 Rev. A