F53 – GPS Operation Mode
F53 – GPS Operation Mode
Use function F53 to set the GPS Receiver in Time Mode or Dynamic Mode.
Select “Dynamic Mode” if the position of the receiver is subject to frequent change, or if it is in
continuous motion. For example, use Dynamic Mode when the XL-GPS is used in mobile
vehicles such as ships, land vehicles, or aircraft. With Dynamic Mode selected, the receiver
updates the position information repeatedly to arrive at the best time calculations for a mobile
environment.
Select “Time Mode” if the receiver used in a static environment such as a server room. With
Time Mode, the receiver averages the position data over time to determine the antenna
position and calculate the time precisely and accurately.
See "Factory Default Jumper and Switch Settings for Options" on page 166
Keypad
While viewing the Status screen on the XL-GPS front panel display, press the following
keypad buttons:
ENTER 53 ENTER
If a GPS Receiver is not available, F53 displays:
GPS AVAILABILITY
NOT AVAILABLE
Note: If F53 indicates that receiver is not available, reset the receiver. If availability is still an
issue, call customer service.
If a GPS Receiver is available, F53 displays:
GPS MODE SELECT
TIME MODE (or DYNAMIC MODE)
To change the mode, use the UP/DOWN ARROW buttons and press ENTER. F53 asks:
SAVE CHANGES?
YES
To save changes, press ENTER.
Command Line
To request the GPS operation mode of an GPS Receiver, enter:
098-00116-000 Rev. A............................... Page 79 of 221
To Next Page
Loading...
Need help?
General
