Command Line Interface
UP ARROW
Will change “0” to “1”, if the second number is 2 or less. For
example 01 wil become 11, but 08 will not become 18.
ENTER XL-GPS asks “SAVE CHANGES? YES”
UP ARROW Changes “YES” to “NO”
ENTER Abandons the changes and displays the Status Display
Other ways to abandon new settings in a function:
Press Result
CLR Abandons all changes and displays to the first screen in the function
TIME Abandons all changes, exits the function, and displays the Time Display
STATUS Abandons all changes, exits the function, and displays the Status Display
To enter numeric values in a function:
Press Result
ENTER Displays the “FUNCTION” prompt
3 Enters “3” as the function number
ENTER Opens Function 3, displays the first screen, “TIME MODE – LOCAL”
ENTER Displays the second parameter, “DATE-TIME…<mm>/<dd>/<yyyy>”
01232010 Enters January 23, 2010 as today’s date. (replace)
ENTER Displays “DATE-TIME”
ENTER XL-GPS asks “SAVE CHANGES? YES”
ENTER Selects “YES”, saves the changes, and displays the Status Display
Command Line Interface
To open a command line session, connect to the serial or network port using a terminal or a
terminal emulation program on a PC.
Consult “5: Function Reference” on page45 for information on the function commands.
098-00116-000 Rev. A............................... Page 41 of 221