EasyManuals Logo

Symmetricom XL-GPS User Manual

Symmetricom XL-GPS
239 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
2: System Specifications
5------GND
6------Rx- (RS-422)
7------Rx+ (RS-422)
8------Tx- (RS-422)
9------Tx+ (RS-422)
Factory settings for RS-232 9600,N,8,1
Network Port 10/100
The Ethernet port interface is:
Type: Standard RJ-45 8 pin connector, 10 Base-T and 100 Base-T standards.
Frame format: IEEE 802.3
J1 - Optional TI/ET
The TI/ET configuration is via the Keypad, Serial I/O, and Network port. J1 accepts an
external 1 PPS or Event input signal and measures it against the system-derived time. The
minimum pulse width of the input signal is 100 nS. The input impedance is selectable at 100
kW or 50 W. The rising edge of the pulse is measured with 5 nS resolution relative to the
system clock time.
Pulse width: 100 nS, min.
Active Edge: Rising
High Level: Logic Hi >1.25 V < 10 V
Low Level: Logic Low < 1.25 V >0 V
Impedance:
100 kW or 50 W
Resolution: 5 nS, single shot
Accuracy:
Refer to “Time and Frequency Accuracy” on page4
Qty: 1
Connector: BNC female
Page 6 of 221 .................................098-00116-000 Rev. A

Table of Contents

Other manuals for Symmetricom XL-GPS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom XL-GPS and is the answer not in the manual?

Symmetricom XL-GPS Specifications

General IconGeneral
BrandSymmetricom
ModelXL-GPS
CategoryReceiver
LanguageEnglish

Related product manuals