F100 – Network Port Configuration & XL-GPS Firmware
OK <CR><LF>
RESETING THE UNIT<CR><LF>
PLEASE WAIT…<CR><LF>
In a network port session, rebooting the XL-GPS terminates the network port session; open
a new network port session when the XL-GPS has finished rebooting. In a serial port
session, the XL-GPS displays text similar to the following example when the XL-GPS has
finished rebooting and is ready to receive additional commands:
SYSTEM POWER ON SELF TEST RESULTS:
SERIAL LOOPBACK TEST PASSED.
RAM TEST PASSED.
PROG CRC TEST PASSED
NETWORK INTERFACE 192-8001 (c) 1998 - 2010 SYMMETRICOM
ALL RIGHTS RESERVED
FLASH FILE SYSTEM MOUNTED.
SOURCE FILE /config/truetime.
SCAN_FOR_OPT_CARD BEGINS.
FOUND @ ADDR 30003000H, ID NUM= 84-21-5000
SCAN_FOR_OPT_CARD ENDS.----
INSTALL_SMART_OPTIONS BEGINS.
FOUND GPS CARD; QTY=1, ID#=80280002H.
QUERYING FOR SYMMETRICOM DEVICE. PLEASE WAIT...
SYMMETRICOM GPS DEVICE.----
XL-GPS
INITIALIZATION SUCCESSFULLY COMPLETED.
>
F100 P – Change User Password
Use function F100 P to change a user password. In a network port session, F100 P changes
the password of the user you logged in as; operator or guest. In a serial port session, F100 P
changes the password of the operator user. See “Command Line Interface” on page41.
Valid password size is from no characters to 64 characters. If more than 64 characters are
entered, F100P truncates the string to 64 characters, saving the first 64 characters entered.
When selecting a password, use appropriate levels password security for the XL-GPS’s
operating environment. Examples include:
• Mixing random alpha and numeric characters, (special characters are also allowed).
• Avoiding words or word combinations that can be found in a dictionary
To change the user password, enter:
F100<S>P<CR>
where:
098-00116-000 Rev. A............................... Page 123 of 221