EasyManuals Logo

Symmetricom XL-GPS User Manual

Symmetricom XL-GPS
239 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
3: Installation/Configuration
Initiate a serial port connection between the terminal emulation program and the XL-GPS.
(The Serial Port connection does not require you to log in.)
Once connected, press the Enter key on your keyboard to get a command prompt.
From the command prompt, >”, you can use the functions described in the “5: Function
Reference” section. The ‘Command Line’ sub-sections provide instructions and examples.
Troubleshooting Tip: If the terminal emulation software has trouble displaying XL-GPS
responses (looks like the unit doesn’t respond to inputs), add a 1 ms/character delay to the
software’s serial port settings.
Connecting to the Network Port
The network port provides remote access to the XL-GPS’s command line interface.
Complete the following steps to connect to the network port.
1. Use function F100 Network Port Configuration & XL-GPS Firmware(page107), or
F100 IP IP Address(page109), to obtain the XL-GPS’s IP address.
2. Open a telnet session from your PC to the XL-GPS.
- In Windows, click Start Run, enter telnet ###.###.###.### (where the
#s are the XL-GPS’s IP address), and click OK.
- Open a telnet session using a program such as HyperTerminal, TeraTerm Pro,
or Minicom. Consult the program’s documentation for instructions.
3. Log in as user name operator and password, janus”. Press Enter on your key-
board to get a command prompt.
From the command prompt, >”, you can use the functions described in the “5: Function
Reference” section. The ‘Command Line’ sub-sections provide instructions and examples.
Related topics:
l
“Configuring the Network Port” on page29
l
“F100 Network Port Configuration & XL-GPS Firmware” on page107
l
“F100 L/LOCK/UNLOCK Remote Lockout” on page114
Verifying Antenna Installation
After completing the above steps, use the keypad to verify the following:
In F119 GPS Receiver Configuration(page143), after approximately 20 minutes
of operation, check that GPS STATUS is LOCKED and GPS ANTENNA is OK.
Page 32 of 221 .................................098-00116-000 Rev. A

Table of Contents

Other manuals for Symmetricom XL-GPS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom XL-GPS and is the answer not in the manual?

Symmetricom XL-GPS Specifications

General IconGeneral
BrandSymmetricom
ModelXL-GPS
CategoryReceiver
LanguageEnglish

Related product manuals