5: Function Reference
ST
= specify ST command
<CR>
= input line terminator
XL-GPS responds:
F100<S>ST<S>FLASH/C-
RC:<S><STATUS>,<S>RAM:<S><STATUS>,<S>SERIAL:<S><STATUS>,
<S>NVRAM<S>VER:<S><STATUS><CR><LF>
where:
F
= ASCII character F
100
= Unit function number
<S>
= Space
ST
= Specify ST command
FLASH/CRC:
= Specify flash checksum result
RAM:
= Specify RAM test result
SERIAL:
= Specify Serial Port test result.
NVRAM VER:
=
Specify version test result. This test compares the version of the code against
the version recorded in Non-Volatile memory
<STATUS>
= Is either ASCII PASS or FAIL
,
= ASCII comma
:
= ASCII colon
<CR><LF>
= Output line terminator
An example of the response is:
F100 ST FLASH/CRC : PASS, RAM : PASS, SERIAL : PASS, NVRAM VER :
PASS<CR><LF>
F100 BH – Burn Host
Use function F100 BH, when upgrading firmware, to select the FTP host and the file to be
transferred.
To select the FTP host and file for upgrading, enter:
F100 BH <FTP HOST IP ADDRESS><S><UPGRADE FILE PATH>/<FILE NAME><CR>
Page 116 of 221 .................................098-00116-000 Rev. A