5: Function Reference
In this case, the new user name will be used for the next login using the command line
interface. However, if the new user name is entered differently the second time, XL-GPS
responds:
ERROR: USER NAMES DO NOT MATCH. NEW USERNAME REJECTED!<CR><LF>
In this case, the old user name will be used for the next login using the command line
interface.
If you have forgotten the operator or guest user name and/or password, use “Bootloader
Mode” to change them. In Bootloader Mode, log in using the default user names (“operator”
and ”guest”) and passwords (See “Using the Command Line Interface” on page31.). Then
use F100 PN and F100P to set the new user names and passwords. Once this has been
completed, reboot the unit and log in using the new username or password. See “F100 P –
Change User Password” on page123.
Bootloader Mode
To enter Bootloader Mode when resetting a forgotten user name (F100 PN) or password
(F100 P):
• Reboot the XL-GPS using the F100 K I L L – Reboot command.
• Immediately press the MENU key on the keypad and hold down while the XL-GPS is
rebooting. The XL-GPS will display will ‘hang’ while displaying “BOOTING”.
• After a few moments, release the MENU key.
• Open a command line session with the XL-GPS.
• Use the F100 PN or F100 P commands as needed and then reboot the XL-GPS
again.
Page 126 of 221 .................................098-00116-000 Rev. A
To Next Page
Loading...
Need help?
General
