Symmetricom XL-GPS User Manual

7: XL-GPS Generated Messages
You have incorrectly entered a parameter, or there is no room currently in the Host table for
another IP Address.
Recovery Action: Verify correct parameter values. If correct, restart the XL-GPS. If this error
message persists, contact Symmetricom Technical Customer Service.
ERROR: Action (get or set) is not specified
You have omitted the “get” or “set” parameter from the F100 NTP Configuration command.
Recovery Action: Re-enter the command, specifying the desired action.
ERROR: Can’t open source file <NAME>
The file containing the needed data is unavailable.
Recovery Action: Check file location and directory names to verify the path is accurate, then
re-enter the command.
ERROR: Can’t open dest file <NAME>
The destination file is unavailable.
Recovery Action: Check file location and directory names to verify the path is accurate, then
re-enter the command.
ERROR: Can’t write file <NAME>
Data from the source file cannot be copied to the destination file.
Recovery Action: Check file location and directory names to verify the path is accurate, then
re-enter the command.
ERROR: Configuration failed.
Your attempt to configure new parameters was unsuccessful.
Recovery Action: Verify parameter values, then re-enter the command.
ERROR: Configuration type is not specified
You did not specify the file type.
Recovery Action: Re-enter the command, specifying SNMP and/or NTP.
Page 168 of 221 .................................098-00116-000 Rev. A

Symmetricom XL-GPS Specifications

General

Brand	Symmetricom
Model	XL-GPS
Category	Receiver
Language	English