122
No Network Available
This unit is not connected to the network.
• Check the network connection. (⇒ 28)
Not Measured
• Measuring the output signal for the output
correction function (LAPC) has not been done yet.
• Measure the output signal. (⇒ 104)
Not Valid
The function you have tried to use is not available
with the current settings.
• Check the steps and settings.
• Registration/subscription may be required for
some functions.
Operate via App
Operation from the unit or remote control is not
available.
• Use the connected device or application for
operating.
Please Wait
This is displayed, for example, when this unit is
turned to standby/on. (For up to approx. 1 minute
and 30 seconds)
• Wait for the display disappears.
“Remote
” (“ ” stands for a number.)
The remote control and this unit are using different
modes.
• Change the mode on the remote control. (⇒ 21)
Searching
The unit is checking the media server on the
network.
• Check to see if there is a server in same network.
Unlocked
“COAX”, “OPT1”, “OPT2”, “HDMI ARC”, “ TV
(OPT2)” or “USB-B” is selected, but no device is
connected or no audio is played back.
The sampling frequency components, etc. of the
audio signals are not input correctly.
• Check the connection with the device. (⇒ 55)
• For supported formats, refer to “Format”. (⇒ 131)
USB Over Current
USB device connected to this unit is drawing too
much power.
• Disconnect the USB device and turn the unit to
standby and on again. (⇒ 52)
• Turn this unit off and on.
• Check if there is no problem on the USB device.
(⇒ 123)
Wi-Fi Setup
Select “Yes” and press [OK] to enter the network
setting. (⇒ 31)
• To exit the network setting, select “No” and press
[OK].
To Next Page
Loading...
Need help?
General
